Printronix T5000 User Manual page 308

Prop. Spacing, 187
PROPRINTER SETUP Menu, 152
Protect Configs., 92
P-SER XQ SETUP Menu, 148
PSeries Dbl High, 188
P-SERIES SETUP Menu, 145
Ptr Media Dist, 202
Ptr On Time, 202
Ptx Setup Parse, 121
Ptx Setup SFCC, 119
Pwr Save Control option, 118
PWR SUPPLY HOT fault message, 264
Pwr Up Auto-Cal, 111
Q
Quiet Zones, 88
R
RAM Disk Size, 121
Rbn Takeup Full, 107
RBN TAKEUP FULL Remove Used Rbn fault
message, 264
Received Data (RD) signal
RS-232 serial interface, 239
RS-422 serial interface, 240
Remove Label fault message, 264
Removing media from the rewinder, 54
Removing the media guide, 48
Repeat Form Opt, 188
Report Status (C/T Port), 217
Report Status (Parallel Port), 206
Report Status (Serial), 212
Request to Send, 213
Request To Send (RTS) signal, RS-232 serial
interface, 239
Reset Cfg Names, 93
Reset Cmd CFG Ld, 188
Reset Head Data, 203
RESETTING PLEASE WAIT fault message, 264
Resistors, configuration, 238
Resp. Polarity, 207
RESTORING BOOT CODE fault message, 264
Rewinder, 275
removing printed media from, 54
308
Ribbon, 23
loading, 34, 45
Printronix, 277
Ribbon 8300, 277
Ribbon 8500, 277
Ribbon 8550, 277
Ribbon 8600, 277
Ribbon 8630, 277
Ribbon 8700, 278
Ribbon 8725, 278
ribbon specifications, 272
RIBBON BROKEN Reload Ribbon fault
message, 264
RIBBON DETECTED In Direct Mode fault
message, 265
RIBBON FAULT Timeout fault message, 265
Ribbon Low, 107
Ribbon Low fault message, 265
RIBBON OUT Load Ribbon fault message, 265
Ribbon specifications, 272
Ribbon Width, 106
Right Margin, 188
Roll media, 35
Rot. Char Size, 189
RS-232 serial interface
Clear To Send (CTS), 239
Data Carrier Detect (DCD), 239
Data Set Ready (DSR), 239
Received Data (RD), 239
Request To Send (RTS), 239
Transmitted Data (TD), 239
RS-422 serial interface
received data (RD), 240
transmitted data (TD), 240
Running auto calibrate, 63
Running media profile, 64
S
Save Char to Fls, 118
Save Config., 92
Save Set to Flsh, 119
Saving new configurations, 72
Scalable Size, 189