Printronix T5000 User Manual page 106

Chapter 3
MEDIA CONTROL
Clip Page
This option determines how the printer handles images that are too large for
one physical page length when using gap or black mark media.
•
Enable. When the user selected page length is greater than the physical
page length, the printer clips the excess data to fit the physical page. The
excess data is lost. The media sensor will constantly look for the gap,
notch, hole, or black mark and when detected, will use it as the Top-of-
Form position for the next label and clip any remaining data from the label
being printed.
•
Disable. When the user selected page length (logical length) is greater
than the physical page length dictated by the gap, notch, hole, or black
mark on media, the printer continues to print the remaining excess data
onto the next physical page.
The media sensor will look for the gap, notch, hole, or black mark only
after the media has advanced the distance specified by the Label Length
value in the MEDIA CONTROL menu or by the Host Forms Length value
sent via software. Any gaps, notches, holes, or black marks that exist
prior to reaching the Label Length or Host Forms Length value will be
ignored.
The factory default is Enable.
Error Recover
This option determines how the printer handles data that was printing when
an error occurred.
•
Disable. The printer will not reprint the label that was printing when the
error condition occurred.
•
Enable. The printer reprints the label that was printing when the error
condition occurred.
The factory default is Disable.
Ribbon Width
When Same As Paper is selected, the printer automatically adjusts the ribbon
operating parameters to match the installed media width. In those cases
where the media width is less than the installed ribbon width, the Set In Menu
option should be selected. After selection, the ribbon width is set to the proper
value by pressing the ↓ key and choosing the actual ribbon width using the +
and - keys. The chosen width is then selected by pressing the ↵ key. The
factory default is Same As Paper.
Display Ribbon
When enabled, the remaining length of unused ribbon will be displayed on the
LCD when in the online mode.
The options are Enable (the factory default) and Disable.
106