Appendix D
Prepare The Printer
Installing The Heavy-Duty Cutter
RJ-11 Receptacle
RJ-11 Connector
Metal Tab (2)
Magnetic Catch (2)
1. Plug the RJ-11 connector into the RJ-11 receptacle.
2. Pull the metal tabs from the magnetic catches and swing open the cutter
assembly mounting bracket from the cutter assembly.
3. Place the cutter assembly in position.
4. Install the two screws using the appropriate metric hex key.
5. Place the cutter assembly into the up (closed) position.
NOTE: The printer cannot detect the presence of the cutter unless the cutter
Restore The Printer To Operation
1. Set the printer power switch to | (ON).
2. Press
3. Press the ↓ and ↵ keys at the same time until "ENTER SWITCH
UNLOCKED" appears on the printer display.
286
Screw (2)
Figure 3. Heavy-Duty Cutter Assembly
is in the up (closed) position and the cutter top cover is installed when
the printer is powered on.
. .
to place the printer in Menu Mode.
.
Lower Support Assembly
Cutter Assembly
Mounting Bracket
Cutter Assembly