Format Control - Printronix T5000 User Manual

Form Length (lines)
(From page 147, page 149, page 151, page 153, page 155.)
Form length is the number of lines that can be printed on a label. You can set
forms length as a function of the current LPI (lines per inch).
The factory default is shown in Table 2 on page 98.
Form Length (mm)
(From page 147, page 149, page 151, page 153, page 155.)
Form length is the number of lines that can be printed on a label. You can set
forms length in millimeters.
The factory default is shown in Table 2 on page 98.
Form Width (char.)
(From page 147, page 149, page 151, page 153, page 155.)
The forms width can be specified as a function of the current CPI (characters
per inch). The forms width set should not exceed the actual paper width.
The factory default is the maximum printing width divided by the selected
number of characters per inch.
Form Width (in.)
(From page 147, page 149, page 151, page 153, page 155.)
In this submenu, form width is specified in inches. The forms width set should
not exceed the actual paper width.
The factory default is the maximum printing width.
Form Width (mm.)
(From page 147, page 149, page 151, page 153, page 155.)
In this submenu, form width is specified in millimeters. The forms width set
should not exceed the actual paper width.
The factory default is the maximum printing width.

Format Control

(From page 129, page 131, page 138.) Enables the printer to reflect the same
spacing as CTPC model printers after absolute and relative move commands
are executed.
•
Disable. Reflects distance, generated by the VGL feature, PGL feature,
and Hex Transparent control code sequence, in the new position (after
horizontal and vertical tabs are executed).
175