Beam Shift; I2Of5 Checksum - Printronix T5000 User Manual

Chapter 3
VALIDATOR

Beam Shift

This option enables you to shift the beam horizontally to the left or right. The
left edge of the beam should be 0.13 inch to the left of the left edge of the tear
bar. After you set this value, save it as part of the configuration for future use.
The range is from -99 to 99, and the factory default is 0.

I2of5 Checksum

This option allows you to include or exclude the checksum option in I2of5 as
part of the grading. For example, if this option is set as enabled, then any
incoming barcode data without checksum digits will be graded as failure and
CHECKSUM FAILURE will display on the LCD.
The factory default is Disable.
Num Retry
This option allows you to set a number of retries for overstrike before the
printer stops.
The options are 3, 4, and 5, and the factory default is 5.
90