Ethernet Params Submenus - Printronix T5000 User Manual

Chapter 3
ETHERNET PARAMS

ETHERNET PARAMS Submenus

IP Address
This item allows you to set the IP Address for the TCP/IP protocol. If the
IP Address is assigned by Bootp, ARP or DHCP, it is dynamic and read-only.
The factory defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
NOTE: When changing the IP Address, the printer resets the Network
Gateway Address
This item allows you to set the Gateway Address for the TCP/IP protocol. If
the Gateway Address is assigned by Bootp, ARP or DHCP, it is dynamic and
read-only.
The factory defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
NOTE: When changing the Gateway Address, the printer resets the NIC
Subnet Mask
This item allows you to set the Subnet Mask for the TCP/IP protocol. If the
Subnet Mask is assigned by Bootp, Arp or DHCP, it is dynamic and read-only.
The factory defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
NOTE: When changing the Subnet Mask, the printer resets the NIC when the
MAC Address
This item is the Manufacturer's Assigned Number, and is unique for each NIC.
It is read-only.
220
Interface Card (NIC) when the printer is placed online. When the
printer resets the NIC, the LCD displays DO NOT POWER OFF. After
the NIC has completed its initialization, the LCD displays E-NET INIT
to signal that the NIC and printer are in the initialization process.
When both the NIC and printer have completed initialization, the LCD
displays E-NET READY.
when the printer is placed online. When the printer resets the NIC, the
LCD displays DO NOT POWER OFF. After the NIC has completed its
initialization, the LCD displays E-NET INIT to signal that the NIC and
printer are in the initialization process. When both the NIC and printer
have completed initialization, the LCD displays E-NET READY.
printer is placed online. When the printer resets the NIC, the LCD
displays DO NOT POWER OFF. After the NIC has completed its
initialization, the LCD displays E-NET INIT to signal that the NIC and
printer are in the initialization process. When both the NIC and printer
have completed initialization, the LCD displays E-NET READY.