Page Rotation; Pgl Normal; Pi Slew Range; Position Aft Ff - Printronix T5000 User Manual

PA1
(From page 128, page 134.) PA1 is only valid when the printer is in the offline
state and the coax Systems Network Architecture Character Set (SCS) data
stream is active. This function displays the "PA1 ENABLED" message when
the ENTER key is pressed and sends a special operator request to the host
when the printer is put back in online mode. Refer to the Coax/Twinax
Programmer's Reference Manual for more information about SCS.
NOTE: Selecting the PA1 menu item again ("PA1 DISABLED" appears on the
operator panel) or selecting the PA2 menu item will reset the pending
PA1 function.
PA2
(From page 128, page 134.) PA2 is only valid when the printer is in the offline
state and the coax SCS data stream is active. This function displays the "PA2
ENABLED" message when the ENTER key is pressed and sends a special
operator request to the host when the printer is put back in online mode.
NOTE: Selecting the PA2 menu item again ("PA2 DISABLED" appears on the
operator panel) or selecting the PA1 menu item will reset the pending
PA2 function.

Page Rotation

(From page 136.) This option rotates the physical IPDS page.
The options are 0, 90, 180, and 270.
The factory default is 0.

PGL Normal

(From page 141.) This option determines whether PGL prints the text data in
NORMAL mode according to the LP+ menu settings or whether PGL will print
the text data according to its own internal state.
The options are LP+ Menu (the factory default) and PGL Menu.

PI Slew Range

(From page 140.) You can specify how many lines the paper will feed.
•
15. A paper slew of 1-15 will move 1-15 lines. A paper slew of 0 will move
1 line.
•
16. A paper slew of 0-15 will move 1-16 lines.
The factory default is 16.

Position Aft FF

(From page 128.) Allows you to select the location of the print position after a
form feed command is sent.
•
Off. Sets the printer to print at position 2 of the first print line on the next
form.
185