Juniper J-series Services Router J4350 Getting Started Manual page 240

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide
Packing the Services Router for Shipment
To pack the router for shipment, follow this procedure:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
Packing Components for Shipment
To pack and ship individual components, follow these guidelines:
218
Packing a Router or Component for Shipment
Flat-blade screwdriver, approximately 1/4 in. (6 mm)
Phillips (+) screwdrivers, numbers 1 and 2
Retrieve the shipping carton and packing materials in which the router was
originally shipped. If you do not have these materials, contact your Juniper
Networks representative about approved packaging materials.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the router is disconnected from earth ground. For more information about ESD,
see "Preventing Electrostatic Discharge Damage" on page 251.
On the console or other management device connected to the master Routing
Engine, enter CLI operational mode and issue the following command to shut
down the router software.
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
has halted. For more information about the command, see the J-series Services
Router Administration Guide.
Shut down power to the router by pressing the power button on the front panel
of the router.
Disconnect power from the router. For instructions, see "Replacing AC Power
Supply Cords" on page 191 and "Replacing DC Power Supply Cables" on page 194.
Remove the cables that connect to all external devices. For instructions, see
"Removing PIM Cables" on page 175.
Remove all field-replaceable units (FRUs) from the router.
If the router is installed on a wall or rack, have one person support the weight
of the router, while another person unscrews and removes the mounting screws.
Place the router in the shipping carton.
Cover the router with an ESD bag, and place the packing foam on top of and
around the router.
Replace the accessory box on top of the packing foam.
Securely tape the box closed.
Write the RMA number on the exterior of the box to ensure proper tracking.