Cli Configuration Mode - Juniper J-series Services Router J4350 Getting Started Manual

At the top level of operational mode are a number of broad groups of CLI commands
that are used to perform the following functions:
To control the CLI environment, see "Configuring the CLI Environment" on page 97.
To enter configuration mode, see "CLI Configuration Mode" on page 93. For
information about the other CLI operational mode functions, see the J-series Services
Router Administration Guide.

CLI Configuration Mode

To configure the Services Router, including system parameters, routing protocols,
interfaces, network management, and user access, you must enter configuration
mode. In configuration mode, the CLI provides commands to configure the router,
load a text (ASCII) file that contains the router configuration, activate a configuration,
and save the configuration to a text file.
You enter configuration mode by entering the
The CLI prompt changes from
To view a list of configuration mode commands, type a question mark (?) at the
command-line prompt. (You do not need to press Enter after typing the question
mark.)
user@host# ?
Possible completions:
set Set CLI properties, date/time, craft interface message
show Show system information
ssh Start secure shell on another host
start Start shell
telnet Telnet to another host
test Perform diagnostic debugging
traceroute Trace route to remote host
Control the CLI environment.
Monitor and troubleshoot the router.
Connect to other systems.
Manage files and software images.
Control software processes.
Stop and reboot the router.
Enter configuration mode.
Enter Execute this command
activate Remove the inactive tag from a statement
annotate Annotate the statement with a comment
commit Commit current set of changes
copy Copy a statement
deactivate Add the inactive tag to a statement
delete Delete a data element
edit Edit a sub-element
exit Exit from this level
help Provide help information
Chapter 4: Services Router User Interface Overview
configure operational mode command.
to
user@host> user@host#
Using the Command-Line Interface
.
93