Removing The Ac Power Inlet Cover (Dc-Powered Routers Only) - Juniper MX960 Hardware Manual

288
Figure 75: Removing the Craft Interface
Figure 76: Removing the Upper Fan Tray

Removing the AC Power Inlet Cover (DC-Powered Routers Only)

A DC-powered router contains a cover over the four unused AC power inlets in the rear of the chassis. If
you have a DC-powered router, remove the cover by following this procedure:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.