Router Power Requirements; Ac Power, Connection, And Power Cord Specifications - Juniper J-series Services Router J4350 Getting Started Manual

CAUTION: To comply with intrabuilding lightning/surge requirements, intrabuilding
wiring must be shielded, and the shield for the wiring must be grounded at both
ends.

Router Power Requirements

Table 54 on page 109 and Table 55 on page 109 list the AC and DC power system
electrical specifications for J-series Services Routers.
Table 54: AC and DC Power System Electrical Specifications for J2320 and J2350 Routers
Item
AC input voltage
AC input line frequency
AC system current rating
DC input voltage
DC system current rating
Table 55: AC and DC Power System Electrical Specifications for J4350 and J6350 Routers
Item
AC input voltage
AC input line frequency
AC system current rating
DC input voltage
DC system current rating

AC Power, Connection, and Power Cord Specifications

NOTE: The AC power cord for the Services Router is intended for use with the router
only and not for any other use.
Specification
100 to 240 VAC nominal
50 to 60 Hz
J2320 Services Routers: 3.2 A to 1.3 A
J2350 Services Routers: 3.5 A to 1.5 A
–48 to –60 VDC operating range
7.2 A
Specification
100 to 240 VAC nominal
50 to 60 Hz
J4350 Services Routers: 6 A
J6350 Services Routers: 8 A
–48 to –60 VDC operating range
20 A
Power Guidelines, Requirements, and Specifications
Chapter 5: Preparing for Router Installation
109