Connecting To A Services Router; Connecting To The J-Web Interface; Connecting To The Cli Locally; Connecting To The Cli Remotely - Juniper J-series Services Router J4350 Getting Started Manual

Connecting to a Services Router

You can connect to the Services Router using the J-Web or CLI interface.
This section contains the following topics:

Connecting to the J-Web Interface

If you plan to use the J-Web interface to configure the Services Router, you must
connect through one of the built-in Ethernet management ports, as shown in
Figure 67 on page 138 and Figure 68 on page 139.
When the Services Router is powered on for the first time, the system looks for a
DHCP server, and if it does not find one, it assigns an IP address within the
192.168.1.0/24
To connect to the J-Web interface through port 0 on the router (see Figure 67 on page
138 and Figure 68 on page 139):
1.
2.
3.
4.
5.
6.
A management device, such as a PC or laptop, with a serial port and an
asynchronous terminal application (such as Microsoft Windows
Hyperterminal)
An RJ-45 to DB-9 serial port adapter (provided)
An Ethernet cable (provided)
For a remote connection, two dial-up modems
For a remote modem connection, a DB-9 female to DB-25 male adapter, or
other adapter appropriate for your modem (not provided)
Connecting to the J-Web Interface on page 137
Connecting to the CLI Locally on page 139
Connecting to the CLI Remotely on page 141
subnetwork to any devices connected to it.
On the management device, such as a PC or laptop, you use to access the J-Web
interface, verify that the address of the port that you connect to the router is set
to one of the following:
An Ethernet address on the
192.168.1.1
An Ethernet address from a DHCP server
Turn off the power to the management device.
Plug one end of the Ethernet cable into the Ethernet port on the management
device.
Connect the other end of the Ethernet cable to the built-in Ethernet port on the
router.
Power on the router by pressing the power button on the front panel.
Wait until the LED on the front panel turns solid green.
STATUS
Chapter 7: Establishing Basic Connectivity
192.168.1/24 subnetwork other than
Connecting to a Services Router
137