Connecting To The Cli At The User End; Configuring Basic Settings With J-Web Quick Configuration - Juniper J-series Services Router J4350 Getting Started Manual

Connecting to the CLI at the User End

To remotely connect to the CLI through a dial-up modem connected to the console
port on the router:
1.
2.
3.
4.
5.
6.
7.

Configuring Basic Settings with J-Web Quick Configuration

J-Web Quick Configuration allows you to configure basic settings. Figure 71 on page
144 shows the Quick Configuration page for basic setup.
At your remote location, connect a modem to a management device such as a
PC or laptop computer.
On the PC or laptop computer, start your asynchronous terminal emulation
application (such as Microsoft Windows Hyperterminal).
Select the COM port to which the modem is connected (for example,
Configure the port settings as follows:
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
In the HyperTerminal window, enter
An OK response verifies that the modem communicates successfully with the
COM port on the PC or laptop.
To dial the modem that is connected to the console port on the router, enter
ATDT remote-modem-number
to the console port on the router is
The router login prompt appears.
Log in as the user . No password is required at initial connection, but you
root
must assign a root password before committing any configuration settings.
Configuring Basic Settings with J-Web Quick Configuration
Chapter 7: Establishing Basic Connectivity
.
AT
. For example, if the number of the modem connected
0013033033030 , enter
COM1 ).
ATDT 0013033033030 .
143