Juniper J-series Services Router J4350 Getting Started Manual page 234

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide
CAUTION: Use extreme caution when disabling J-series power management. To
prevent equipment damage, do not install a combination of PIMs that exceeds the
power or heat capacity of your router when J-series power management is disabled.
To reenable J-series power management, remove the
disable-power-management
about the
see the JUNOS System Basics Configuration Guide.
Contacting the Juniper Networks Technical Assistance Center
If you need assistance while troubleshooting a Services Router, open a support case
using the Case Manager link at
(within the United States) or 1-408-745-9500 (from outside the United States). For
more information, see "Contacting Customer Support and Returning
Hardware" on page 213.
212
Contacting the Juniper Networks Technical Assistance Center
user@host# set chassis fpc 2 offline
If the power and heat tokens no longer exceed the maximum, the PIMs that
were placed offline by J-series power management are brought online
automatically.
Use the set chassis disable-power-management
power management:
user@host# set chassis disable-power-management
The
set chassis disable-power-management
online automatically.
command from the configuration. For detailed information
set chassis fpc offline and
http://www.juniper.net/support/
command to disable J-series
command brings the offline PIMs
set chassis
set chassis disable-power-management
, or call 1-888-314-JTAC
commands,