Juniper J-series Services Router J4350 Getting Started Manual page 164

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide
3.
4.
5.
6.
7.
8.
9.
Connecting the Modem to the Console Port
NOTE: Most modems have an RS-232 DB-25 connector. You must separately purchase
an adapter to connect your modem to the RJ-45 to DB-9 adapter and Ethernet cable
supplied with the router.
To connect the dial-up modem to the console port on the router:
1.
2.
3.
4.
5.
6.
7.
8.
9.
142
Connecting to a Services Router
From the PC or laptop computer, start your asynchronous terminal emulation
application (such as Microsoft Windows Hyperterminal) and select the
to which the modem is connected (for example,
Configure the port settings as follows:
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
In the HyperTerminal window, enter
An response verifies that the modem communicates successfully with the
OK
COM port on the PC or laptop.
To configure the modem to answer a call on the first ring, enter
To configure the modem to accept modem control Data Terminal Ready (DTR)
signals, enter AT&D1 .
To disable flow control, enter
To save modem settings, enter
Turn off power to the router.
Turn off the power to the modem.
Plug one end of the Ethernet cable supplied with your router into the console
port on the router.
Plug the other end of the Ethernet cable into the RJ-45 to DB-9 serial port adapter
supplied with your router.
Connect the serial port adapter to a separately purchased DB-9 female to DB-25
male adapter, or other adapter appropriate for your modem.
Plug the modem adapter into the DB-25 connector on the modem.
Connect the modem to your telephone network.
Turn on the power to the modem.
Power on the router by pressing the power button on the front panel. Verify that
the LED on the front panel turns green.
POWER
COM1 ).
.
AT
.
AT&K0
AT&W .
port
COM
.
ATS0=1