Replacing A Pim; Removing A Pim; Installing A Pim - Juniper J-series Services Router J4350 Getting Started Manual

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide
Table 69: Tools and Parts Required
Tool or Part
Electrostatic bag or antistatic mat
Electrostatic discharge (ESD)
grounding wrist strap
Flat-blade screw-blade screwdriver,
approximately 1/4 in. (6 mm)
Phillips (+) screwdriver, number 1
and number 2
Replacing the Console Port Cable
The RJ-45 port labeled
connect the router to an external management device, such as a laptop or a terminal
server. For cable specifications, see "Chassis Console Port Pinouts" on page 234.
To replace the console port cable:
1.
2.
3.

Replacing a PIM

To remove or install field-replaceable Physical Interface Modules (PIMs) in a Services
Router, you must first power off the router. This section contains the following topics:

Removing a PIM

The PIMs are installed in the front of the Services Router. A PIM weighs less than
1 lb (0.5 kg).
172
Replacing the Console Port Cable
Components
All
All
PIM
Chassis cover
Compact flash
Crypto Accelerator Module
DRAM modules
PIM
Power system components
CONSOLE
Locate an appropriate replacement cable and connector.
Plug the Ethernet connector at either end of the cable into the console port on
the front panel (see Figure 69 on page 140 and Figure 70 on page 141).
Plug the connector at the other end of the cable into the external management
device. If you are connecting to a DB-9 serial port, use the provided RJ-45 to
DB-9 serial port adapter.
Removing a PIM on page 172
Installing a PIM on page 174
on the Services Router's front panel allows you to