Configuring Basic Settings With A Configuration Editor - Juniper J-series Services Router J4350 Getting Started Manual

Configuring Basic Settings with a Configuration Editor

To establish basic connectivity on a Services Router, you identify the router, connect
the router to the network, and specify basic network settings.
In a typical network, the Services Router has the basic settings listed in
Table 62 on page 147. Determine the values to set on the Services Router in your
network.
Table 62: Sample Settings on a Services Router
Services Router Property
Services Router hostname
Access for user "root"
IP address of the NTP server used to synchronize system time
on the Services Router
Services Router location
IP address of the DNS server to which DNS requests are sent
Domains to which the Services Router belongs
IP address of a backup router to use while the Services Router
is booting or if the routing protocol processes fail to start
Loopback IP address and prefix length for the Services Router
interface
lo0
IP address and prefix length for the Services Router
interface
You can configure basic settings in the J-Web interface from a device attached to the
ge-0/0/0
Interface" on page 137. You can also connect to the CLI to configure basic settings.
For instructions, see "Connecting to the CLI Locally" on page 139 and "Connecting
to the CLI Remotely" on page 141.
To use a configuration editor to configure basic settings:
1.
2.
ge-0/0/0
interface on port 0. For instructions, see "Connecting to the J-Web
Navigate to the top of the configuration hierarchy in either the J-Web or CLI
configuration editor.
To configure basic settings, perform the configuration tasks described in
Table 63 on page 148.
Chapter 7: Establishing Basic Connectivity
Sample Value
routera
SSH RSA public key
10.148.2.21
Sunnyvale, California, USA, which is in the
America/Los_Angeles time zone
10.148.2.32
and
lab.router.net router.net
192.168.2.12/24
172.16.1.24/32
192.168.1.1/24
Configuring Basic Settings with a Configuration Editor
147