Juniper J-series Services Router J4350 Getting Started Manual page 160

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide
7.
8.
9.
NOTE: You must manually configure the IP address for the management port you
are using before you save your initial configuration. When you save the configuration
for the first time, you will lose the connection to the router if you have not manually
configured the IP address. If you lose connection through the management interface,
you must connect through the console port.
Figure 67: Connecting to the Gigabit Ethernet Port on J2320 and J2350 Routers
138
Connecting to a Services Router
Turn on the power to the management device. The router assigns an IP address
to the management device within the
is configured to use DHCP.
From the management device, open a Web browser and enter the IP address
192.168.1.1 in the address field. The Set Up Quick Configuration page appears.
Configure basic settings for your router as described in "Configuring Basic Settings
with J-Web Quick Configuration" on page 143.
subnetwork if the device
192.168.1.0/24