Juniper J-series Services Router J4350 Getting Started Manual page 168

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide
Table 61: Set Up Quick Configuration Summary (continued)
Field Function
Current System Time Synchronizes the system time with the NTP
server, or manually set the system time and
date.
Network
DNS Name Servers Specify a DNS server that the router can use
to resolve hostnames into addresses.
Domain Search Adds each domain name that the router is
included in to the configuration so that they
are included in a DNS search.
Default Gateway Defines a default gateway through which to
direct packets addressed to networks not
explicitly listed in the routing table.
Loopback Address Defines a reserved IP address that is always
available on the router. If no address is
entered, this address is set to
Defines the IP address and prefix length of
ge-0/0/0 Address
ge-0/0/0
used as the management interface for
accessing the router. The DHCP client sets this
address to
is found.
Management Access
Allow Telnet Access Allows remote access to the router using
Telnet.
Allow JUNOScript Allows JUNOScript to access the router using
over Clear-Text a protocol for sending unencrypted text over
Access a TCP connection.
Allow SSH Access Allows remote access to the router using SSH.
146
Configuring Basic Settings with J-Web Quick Configuration
127.0.0.1/32
. The interface is typically
ge-0/0/0
if no DHCP server
192.168.1.1/24
Your Action
To immediately set the time using the NTP server,
click Set Time via NTP. The router sends a
request to the NTP server and synchronizes the
system time.
NOTE: If you are configuring other settings on this
page, the router also synchronizes the system time
using the NTP server when you click Apply or OK.
To set the time manually, click Set Time
Manually. A pop-up window allows you to select
the current date and time from lists.
To add an IP address, type it in the box to the left of
the Add button, then click Add.
To delete an IP address, click on it in the box above
the Add button, then click Delete.
To add a domain name, type it in the box to the left
of the Add button, then click Add.
To delete a domain name, click on it in the box above
the Add button, then click Delete.
Type a 32-bit IP address, in dotted decimal notation.
Type a 32-bit IP address and prefix length, in dotted
decimal notation.
.
Type a 32-bit IP address and prefix length, in dotted
decimal notation.
NOTE: You must enter the
Quick Configuration Set Up page before you click
Apply or OK. If you do not manually configure this
address, you will lose your connection to the J-Web
interface when you click Apply or OK.
To enable Telnet access, select the check box.
To enable JUNOScript access over clear text, select the
check box.
To enable SSH access, select the check box.
address on the
ge-0/0/0