Network Cable Specifications; Isdn Provisioning; Site Preparation Checklist - Juniper J-series Services Router J4350 Getting Started Manual

Network Cable Specifications

The Services Router supports interfaces that use various kinds of network cable. For
information about the type of cable used by each interface, see "Network Cable
Specifications and Connector Pinouts" on page 223.

ISDN Provisioning

You might need a network termination type 1 (NT1) device to connect your ISDN
interface to the ISDN service. Contact your service provider for details on the following
information:

Site Preparation Checklist

The checklist in Table 59 on page 115 summarizes the tasks you need to perform
when preparing a site for Services Router installation.
Table 59: Site Preparation Checklist
Item or Task
Verify that environmental factors such as
temperature and humidity do not exceed router
tolerances.
Measure the distances between external power
sources and the router installation site.
Select the type of rack.
Plan the rack location, including required space
clearances.
Secure the rack to the floor and the building
structure.
Acquire appropriate cables and connectors.
External NT1 device and ISDN cable
If the two items are required, where to obtain the items
List of NT1 vendors
Chapter 5: Preparing for Router Installation
Performed By Date Notes
Network Cable Specifications
115