Icom IC-M71 Instruction Manual page 76

CONTAINERIZED KITCHEN (CK)
OPERATION UNDER USUAL CONDITIONS
Water and Drain System Startup
The water supply hose, internal drain hose, and external drain hose should already be
connected as described earlier in this Work Package. Fill the water system as follows:
The switches for the water pump and water heater (located on the
appliance control box) must be left OFF until the water system and water
heater are filled. Energizing these items without water in them will result
in equipment damage.
In freezing weather, the water tank trailer should be located as close to
the fabric penetration as possible.
freezing are described in WP 0007 00.
1. Ensure that both drain valves in the sink assembly are fully closed. The valves are located
at the back of the assembly under the water heater – one for the heater and one for the cold
water line. If necessary, unlock the sink assembly casters and temporarily move the sink
assembly to check the valves.
2. Open the hot and cold water handles to eliminate back pressure on the pump.
Do not run the water pump for more that approximately one minute
without water. If water is not running from the faucet after this time, shut
off the pump at the appliance control box and check for kinks or leaks in
the supply hose. The water heater must be left OFF until it has been
filled.
3. Position the WATER PUMP switch on the appliance control box to ON.
4. Turn off the cold water when a steady stream of water runs from the faucet. After a short
time for the water heater to fill, turn off the hot water when a steady stream runs from the
faucet. After the water is turned off, the pump will automatically stop after a few seconds.
5. Position the WATER HEATER switch on the appliance control box to ON.
6. To fill the tray pack heater or steam table, retrieve the short water supply hose from the base
of the sink assembly, connect the female end to the faucet, and fill these items as desired.
When no longer needed, drain the hose, coil it, connect its ends together to minimize the
possibility of contamination, and restow it in the sink assembly base.
TM 10-7360-226-13&P
CAUTION
Additional procedures to prevent
CAUTION
0006 00-23
0006 00