Icom IC-M71 Instruction Manual page 101

CONTAINERIZED KITCHEN (CK)
TROUBLESHOOTING PROCEDURES (ELECTRICAL SYSTEM)
Table 1. Troubleshooting Procedures (Electrical System) – Continued
Malfunction
Generator will not
crank
Generator cranks but
does not start
TM 10-7360-226-13&P
Test or Inspection
GENERATOR POWER
AVAILABLE indicator is lit,
GENERATOR POWER indicator is
not lit.
GENERATOR POWER
AVAILABLE indicator is lit,
GENERATOR POWER indicator is
lit
Check that the E-Stop (Main
Control Panel) is reset (pulled out)
Check that DC control power circuit
breaker CB1 (behind generator
control panel) is reset (pushed in)
Check that the E-Stop circuit
breaker (Power Entrance Panel) is
reset (pushed in)
Check that the generator DEAD
CRANK switch is in NORMAL
(behind generator access door
accessible from inside the
mechanical room)
Check generator battery
connections (inside access doors
on both sides of generator)
Check that the generator DEAD
CRANK switch is in NORMAL
(behind generator access door
accessible from inside the
mechanical room)
0010 00-2
Corrective Action
Ensure that the generator
power control circuit breaker
(Power Entrance Panel) is shut
(pushed in)
Notify unit maintenance
Press the GENERATOR
POWER pushbutton (Main
Control Panel)
Notify unit maintenance
Check/reset the input power
circuit breaker (#1 on Power
Distribution Panel).
Notify unit maintenance
Reset E-Stop
Reset circuit breaker
Reset circuit breaker
Place switch in NORMAL
If loose or corroded, notify unit
maintenance
Place switch in NORMAL
0010 00