Icom IC-M71 Instruction Manual page 129

TM 10-7360-226-13&P
CONTAINERIZED KITCHEN (CK) 0017 00
UNIT MAINTENANCE PROCEDURES
REPAIR
Fabric Repair, Outside Surface or Awning: To repair a tear in the outer fabric or awning, use
the fabric repair kit. Cut a patch of at least a one-inch greater size than the tear in all directions.
Round the corners of the patch. Thoroughly clean the cover surface and roughen it with an
abrasive file.
Apply an even coat of vinyl cement to both surfaces and let them dry for 2 to 5 minutes.
With an assistant supporting the vinyl from inside the shelter, press firmly to bond the surfaces.
o
Allow twenty-four hours at 60 F or more to cure before folding up the cover.
Fabric Repair, Inside Surface: With gray duct tape (or equal), cover the tear in the insulation
area or tape a patch in place covering all edges. Cut a strip of tape longer than the tear in the
inner liner.
Press one long edge of the tape to the area of the tear ensuring that the ends of the tape extend
past the end of the tear on both ends. Close the tear and press the other side into the tape with
an assistant on the outside providing support. The final appearance on the inside should be a
nearly straight line following the original tear.
END OF WORK PACKAGE
0017 00-4