Table of Contents
Advertisement
174
CHAPTER 4
Using the Gateway
Sensor Types
•
discrete nearest - in any case, the nearest discrete value
contained in the table will be used;
•
discrete lower - in any case, the nearest lower discrete
value contained in the table will be used;
•
discrete upper - in any case, the nearest higher discrete
value contained in the table will be used.
•
Input values / Output values - allows you to enter the
corresponding pairs of values of the conversion table:
Figure 181. Conversion Table
•
Input values: - enter the values delivered by a particular
sensor which correspond to the values of physical units
defined by you as output values;
•
Output values: - enter the values of the physical units as
which you want your A850 to interpret the respective
input values.
The "Sensor Type Selection" window allows you to define the sen-
sor types which you intend to use with your RTUs; i.e. each type of
sensor has to be declared only once in this window to allow you to
use it in your RTU network.
Advertisement
Table of Contents
