Table of Contents
Advertisement
•
Node ID - allows to define or to modify a node ID for the
Wireless Modem;
Note: The node ID is always assigned automatically by the A850,
but can be changed by the field "Node ID".
•
First sensor index - displays the index of the first sensor
connected to the Wireless Modem.
Modem-Type dependent settings
Figure 145. Wireless Modem - Modem-Type dependent settings
•
Notification on reset - if the checkbox is marked, a notification
is sent in case of a reset of the Wireless Modem;
•
Log all polls - if the checkbox is marked, all polls will be
registered in the poll journal;
•
Uptime - displays the up time of the Wireless Modem after
the last configuration in hours;
•
Resets - displays the number of resets of the Wireless Modem
after the last configuration in hours;
•
RSSI - displays the actual RSSI (Received Signal Strength
Indication, a measurement of the received radio signal
strength) in dB;
•
Power output - displays the actual power output of the
Wireless Modem in mW;
•
Last ping - displays the time of the last connection of your
Wireless Modem for requesting the status of a RTU;
•
Last time sync - displays the point in time when the last time
synchronization of the Wireless Modem took place;
139
CHAPTER 3
Advertisement
Table of Contents
