Table of Contents
Advertisement
Telemetry Gateway A850 User Manual
Discarding Changes and Refreshing
If you do not want to save the changes, click on the Undo action tool bar
shortcut or close the program without saving.
Click on the Reload configuration tool bar shortcut (blue circle) to refresh. Click
on File on the menu bar and select Exit.
Note
If you made changes but did not save them, you will be asked if you really want
to close the program. Make sure that you really want to perform the individual
operation, or cancel.
Updating the Default Sensor Types
A sensor type includes a class of sensors that can be connected to an RTU to
provide measurement data.
At least two sensor types used together are described as combination sensors.
For example,
sensor.
ADCON provides a range of sensors by default. To use these default sensors, do
the following:
1.
2.
3.
4.
Changing the Password
For security reasons, change the password that was preconfigured at the
factory. When entering a password, make sure to use a combination of upper
and lower case letters, numbers and special characters and that it is at least 6
characters long. A password with 8 characters is recommended.
1.
2.
3.
4.
5.
Wind Speed 270 & Dir
Figure 24. Updating the default sensor types
Lock the configurator for editing.
Click on "Tools" on the menu bar and select "Update Default Sensor Types".
Confirm with "OK". The sensor types for the connected device are added in
Explorer.
Save the configuration or cancel the action.
Figure 25. Changing the password
Lock the configurator for editing.
Click on the Users tab on the tab bar.
Click on
Password
and enter the new password twice.
Confirm with OK.
Save the configuration or cancel the action.
covers the wind speed and direction in a
34
CHAPTER 5
Getting Started
Advertisement
Table of Contents
