Sensor Settings; Conversion Settings - Adcon A850 User Manual

198
CHAPTER 4
Using the Gateway

Sensor settings

Figure 219. Sensor type - Sensor settings - LC
• Logical channel - enter the logical channel of the LC sensor.

Conversion settings

Figure 220. Sensor type - Conversion settings - LC
• Sensor table - if you want to use a non-linear sensor, select
one of the sensor tables already defined in the menu item
"Sensor Tables" for conversion/linearization; if you intend to
use a linear sensor, select "none";
•
Figure 221. Sensor type - Conversion settings - Sensor table - LC
Note: If a sensor table is entered for a non-linear sensor, the fol-
lowing entries for Linear input value refer to the output val-
ues of the linearization table and not to the voltage
measured on the analog pin!
• Linear input value - entry of the minimum and maximum value
of the range within which the sensor delivers measurements;