Output Settings; Conversion Settings - Adcon A850 User Manual

202
CHAPTER 4
Using the Gateway

Output settings

Figure 225. Sensor type - Output settings - OC
• Output channel - enter the output channel for the OC sensor.

Conversion settings

Figure 226. Sensor type - Conversion settings - OC
• Sensor table - if you want to use a non-linear sensor, select
one of the sensor tables already defined in the menu item
"Sensor Tables" for conversion/linearization; if you intend to
use a linear sensor, select "none";
•
Figure 227. Sensor type - Conversion settings - Sensor table - OC
Note: If a sensor table is entered for a non-linear sensor, the fol-
lowing entries for Linear input value refer to the output val-
ues of the linearization table and not to the voltage
measured on the analog pin!
• Linear input value - entry of the minimum and maximum value
of the range within which the sensor delivers measurements;