Tools Communication Direct Commands - Adcon A850 User Manual

58
CHAPTER 2
System Setup

Tools Communication Direct Commands

For RTUs and Wireless Modems, this command allows the user to
initiate radio commands to the respective receiver and effectuates
the responses to be displayed. The user must have the "direct"
access right to the RTU for being able to use this function. Each
command is initiated by sending a "direct" request to the Gate-
way. Before issuing the request entered by the user, the GUI pre-
fixes it with the ID of the targeted RTU or the Wireless Modem if it
is missing. The protocol of the commands sent and the corre-
sponding responses are displayed by a multiline text control, but
can also be exported to a text file and printed. The lines entered
by the user are presented in bold font. The maximum number of
lines available for scrolling is configurable (1000 lines default).
Note: Direct Commands can be used depending on the RTU type
and are described in the respective RTU manuals.
Direct commands can be sent to separate Wireless Modems. To
do this, you first have to select them in "Direct commands", to
choose the corresponding Wireless Modem in the "Table view"
and to mark it by the mouse before you can send the command.