Connecting To The Ip Server Interfaces; Connecting To The Internet Protocol Service Interface Circuit Packs - Avaya S8700 Installation Instructions Manual

Connecting to the IP server interfaces

This section covers the following tasks:
•
Connecting to the internet protocol service interface circuit packs
•
Programming the internet protocol service interface circuit packs
•
•
•
Verifying that IPSIs are translated
•
Verifying connectivity to media server
•
Upgrading IPSI firmware version (if necessary)
•
Enabling IPSI duplication (high or critical reliability only)
•
Enabling control of IPSIs
•
Verifying license status
Connecting to the internet protocol service
interface circuit packs
If duplex reliability, connect one end of the GREEN CAT5 straight-through cable to the IPSI adapter on
the back of media gateway in position A.
If high or critical reliability, in addition connect one end of the RED CAT5 straight-through cable to the
IPSI adapter on the back of media gateway in position B.
Dedicated control network: The other end is connected to the next available port on the Ethernet switch.
Nondedicated control network: The other end is connected to the next available port on the customer's
network. If not already connected, connect it.
For a connectivity guide, see
Media Gateway
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
December 2003
NOTE:
The media gateways must be installed, connected to each other, and powered up.
Using DHCP addressing on page 182
Using static addressing on page 183
on page 188
on page 189
NOTE:
Once the IPSIs are connected to the control network, they may alarm if the firmware is not
the most current. The alarm automatically goes away once the IPSI firmware is upgraded.
Getting Started with the Avaya S8700 Media Server with the Avaya G650
Connecting to the IP server interfaces
on page 187
on page 187
on page 187
on page 187
on page 181
on page 182
181