Telneting To Media Server; Enabling Alarms To Inads Via Modem; Enabling Alarms To Inads Via Snmp - Avaya S8700 Installation Instructions Manual

6
Click Backup now to back up all data to the PCMCIA flashcard.

Telneting to media server

1
Click Start > Run to open the Run dialog box
2
Type
telnet 192.11.13.6
3
Log in as

Enabling alarms to INADS via modem

1
Type almenable -d b
2
Type
almenable

Enabling alarms to INADS via SNMP

1
Type
almsnmpconf -d ipaddress -c communityname
trap receiver address for the SSG device and communityname is the community string name
required by the SSG device.
2
Type
almsnmpconf
Verify that the correct information was entered.
3
At the prompt, type
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
December 2003
and press Enter.
craft or dadmin (if business partner).
NOTE:
These steps must be done on both media servers.
and press Enter
and press Enter to verify that the alarms are enable
NOTE:
Do these steps only if a Secure Service Gateway (SSG) is being installed. For further
information on the SSG device, see (Avaya personnel only): http://135.8.11.4/team-sra/.
NOTE:
These steps must be done on both media servers.
and press Enter.
almenable -s y
Completing the installation administration
.
and press Enter, where ipaddress is the
and press Enter.
d.
253