P333T-Pwr Power Over Ethernet Stackable Switch - Avaya S8700 Installation Instructions Manual

Installing and wiring telephone power supplies
Figure 96: Connecting an IP telephone with an external splitter
Connection to
Power over LAN Hub
Before connecting telephones or other end devices to the 1152A1 PDU, determine if:
•
It is Power over LAN Enabled or not.
If not, you may safely connect the telephone; however, the port supplies no power and functions
as a normal Ethernet data port.
•
It requires an external splitter or whether it requires only a single RJ45 connection.
If an external splitter is needed, be certain to use a splitter with the correct connector and polarity.
•
Its power requirements are consistent with the 1152A1 PDU voltage and power ratings. See
Appendix B in the user's guide that comes with the unit for voltage and power ratings.
To connect telephones and other end devices to the 1152A1 PDU:
1
Connect an Ethernet cable to the telephone using an external splitter or directly (if the device is
Power over LAN Enabled).
2
Connect the opposite end of the same cable to the RJ45 wall outlet.
3
On the front panel of the 1152A1 PDU, monitor the response of the corresponding port LED. If it
lights up GREEN, the unit has identified your telephone as a Power over LAN
P333T-PWR power over Ethernet stackable
switch
The P333T-PWR power supply complies with the Underwriters Laboratories Inc. (UL) standard UL
1950, second edition.
Complies
Approved
Approved
240
RJ-45
Female Socket
UL 1950
CSA C22.2 No.950 Std.
CE Regulatory Compliance
Installing the Avaya S8700 Media Server with an Avaya G650 Media Gateway
RJ-45
Male Connector
Data
Power
DC Power
Connector
IP
Phone
December 2003