System Power Control] Window - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB Web-UI (Web User Interface) Operations
[System] – [System Setup]
(2) Window Operations
Specify the items such as [Power Feed Mode] and [Power Restoration Policy] and click on the [Apply]
button.
Respective information is set.
[Message]
This section describes the messages to be displayed on this window.
Message Number
I_00013
E_00100
W_00426
E_00098
W_00559
E_00100
For details on the messages displayed on the window, see
(C122-E178EN).

1.2.8 [System Power Control] window

In [System Power Control] window, power of the entire PRIMEQUEST 2000 series system can be controlled.
Remarks
·
Please shutdown the OS for the partition in which Windows is installed. In case of emergency such as,
no response from the system, cut the power supply using Power Off (Force Power Off) of MMB.
·
In case of following condition, confirm the contents by referring to "11.2 Troubleshooting" of
PRIMEQUEST 2000 Series Administration Manual
contact your sales representative or sales representative.
Confirm the model name and serial number shown on the label affixed on the main unit and report it.
Moreover, do not [Reset] or [Force Power Off] the partition till the error is solved.
When [Power off], [Reset], [Force Power Off] and shut down of partition is done by operating
-
system, and if the state of each component on the MMB Web-UI screen is displayed in the state in
which processing does not end even for a long time, Part Number and Serial Number are
displayed as "Read Error".
Setting completed.
Failed to set the System Setup
Invalid values specified.
Failed to get the system configuration.
Unable to set Power Save Control because PSU type is not PSU_P.
Failed to set the system config .
Message
PRIMEQUEST 2000 Series Message Reference
(C122-E175EN). If the error could not be solved,