Remove Partition; Set Active_Mmb - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations

2.2.11 remove partition

Remove the specified SB, IOU from the specified partition.
When the specified SB, IOU is not included in specified partition, then execution cannot be done.

Privilege: Administrator
(1) Input format
remove partition <partition#> SB <SB#x> {quiet}
remove partition <partition#> IOU <IOU#x> {quiet}
(2) Option
quiet: Command is executed without interacting with the user.
(3) Usage example

Example: When removing SB#3 from Partition #2 in PRIMEQUEST 2800E
# r remove partition 2 SB 3.
Are you sure to continue removing SB#3 from Partition#2? [Y/N] Y
Removing SB#3 from Partition#2 has been completed successfully.
#

Example: When removing IOU#1 from Partition #2 in PRIMEQUEST 2800E
# remove partition 2 IOU1.
Are you sure to continue removing IOU#1 from Partition#2? [Y/N] Y
Removing IOU#1 from Partition#2 has been completed successfully.
#
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (C122-E178EN).
Are you sure you want to remove %s from Partition#%d? [Y/N]:
Removing %s from Partition#%d has been completed successfully.
The specified partition number is invalid.
The specified [SB|IOU] number is invalid.
The specified parameter is invalid.
Parameter missing
Partition#x does not include the [SB#x | IOU#x].
Unable to execute this command on a standby MMB.
Failed to execute remove partition command.
Failed to execute %s command.
The specified command is not supported.(error=[%s])
The parameter [IOU] is not supported.
Unable to execute this command because the system is under maintenance.
Unable to execute this command because the Partition#x is under maintenance.
Unable to set configuration because the power on/off is processing.
Please execute it after a while again.

2.2.12 set active_mmb

By resetting Active MMB, switch over to Active MMB.
When this command is issued for MMB which is already in Active MMB, nothing is executed.