Show Partition Dynamic_Reconfiguration - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations

Example: When configuration information of partition of partition number 0~2 with PRIMEQUEST
2800E is displayed
# show partition configuration 0-2
0 hogehoge
1 testserver
2
#

Example: When all the specifications for the configuration which are the same as the above-mentioned
are used
# show partition configuration all
0 hogehoge
1 testserver
2
3 <Since nothing is registered, it is displayed as blank>
free
#
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (C122-E178EN).
The specified partition number is invalid.
The specified parameter is invalid.
Unable to execute this command on a standby MMB.
Failed to execute show partition configuration command.

2.3.6 show partition dynamic_reconfiguration

Displays the status of Dynamic Reconfiguration of the specified partition..

Privilege: Aｌｌ
(1) Input format
show partition dynamic_reconfiguration <partition#>
(2) Option
None
(3) Usage example

Example: When the status of Dynamic Reconfiguration of Partition#3 is displayed
# show partition dynamic_reconfiguration 3
current: disabled
setting: enabled
#
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (C122-E178EN).
The specified partition number is invalid.
The specified parameter is invalid.
Unable to execute this command on a standby MMB.
SB#0 SB#0 RSB#3 IOU#0
SB#1 SB#1 IOU#0
SB#2 SB#2 IOU#1
SB#0 SB#0 RSB#3 IOU#0
SB#1 SB#1 IOU#1
SB#2 SB#2 IOU#2
IOU#3