Figure 1.24 [Sb#X Status Clear] Window (Message Display) - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB Web-UI (Web User Interface) Operations
[Message]
This section describes the messages to be displayed on this window.
Message Number
I_00029 Status Clear completed.
E_00048 The specified unit is not installed.
E_00123 Failed to clear the status.
For details on the messages displayed on the window, see
(C122-E178EN).
[SB#x Status Clear] Window
When the [Status Clear] button on the [SB#x] window is clicked, whether to clear the error status of the
component can be specified.
The error status of the component in which an abnormality is detected on the SB is canceled, the relevant
component can be specified so that it can be used again at the time of next reboot. If error is detected again
at the time of re-boot, then the error status of that such component is registered again.

FIGURE 1.24 [SB#x Status Clear] Window (Message Display)

(1) Menu Operation
[System] – [SB] – [SB#x] – [Status Clear] button
(2) Window Operations
1. Specify as given below to clear the component.
·
Select [Clear All Status] to clear all the components.
·
Select [Clear Specified Status] to individually clear the error status of the components, and check
the [Status Clear] checkbox of the status of the components to be cleared.
·
Check the [Clear Status of common parts] check box to clear the common parts.
Message
PRIMEQUEST 2000 Series Message Reference