Table 3.40 Display Contents Of Operation Help Display - Fujitsu PRIMEQUEST 2000 Series Tool Reference

UEFI Menu Operations
Pending TPM operation
Current Status Information
TPM Enabled Status
TPM Active Status
TPM Owner Status
Commit Changes and Exit
Discard Changes and Exit
(3) Operation Help Display
The help for the operations mentioned on this page is shown in
help display".

TABLE 3.40 Display contents of operation help display

Items
 =Move Highlight
<Enter>=Select Entry
Esc=Exit
TPM Activate Status ⇒Activated
 When 'Disabled' is selected
TPM Enabled Status ⇒ Disabled
TPM Activate Status ⇒Deactivated
Performs settings on other TPM chip.
None
Enable Take Ownership
Disable Take Ownership
TPM Clear
Default setting is None.
Remarks
"Pending TPM operation" is displayed when "Enabled" is selected in "TPM
Support".
"TPM Enabled Status" of "Current TPM operation" is "Enabled" and selection
is possible if "TPM Active Status" is "Activated".
In other situations, gray out is displayed and selection is not possible.
Current status of TPM chip is displayed. When TPM Support is set to
Disabled, "SUPPORT TURNED OFF" is displayed.
Warning
Following is the TPM Chip status displayed as TPM Enabled Status, TPM
Activate Status, and TPM Owner Status. No item is set.
However, as the TPM Chip status cannot be read immediately after changing
the settings of [TPM SUPPORT] from [Disabled] to [Enabled],the default
value is set to [Disabled],[Deactivated],[Unowned]
Values which can be set as [TPM State] are displayed as follows.
[Enabled]: When [Enabled] is set as [TPM State]
[Disabled]: When [Disabled] is set as [TPM State]
Values which can be set in [TPM State] are displayed as follows.
[Activated]: When [Enabled] is selected as [TPM State]
[Deactivated]: When [Disabled] is selected as [TPM State]
Shows whether the TPM chip is authorized
[Owned]
[Unowned]
Exit from this menu after saving the changes in the settings.
Exit from this menu after cancelling the changes in the settings.
Moves the cursor up and down.
Selects the items.
Returns to "3.1 Front page of Boot
changes of this menu.
"TABLE 3.40 Display contents of operation
Description
Manager" without saving the setting