Setting of sadump environment
In this menu, items for sadump configuration are listed. The items are displayed as follows in initial state
where sadump is not set up.
TABLE 6.3 Displayed contents of the menu selection area
Item
ENABLE
COMPRESS
RECYCLE
REBOOT
Restore to factory settings
Commit Changes and Exit
Discard Changes and Exit
FIGURE 6.6 sadump setup menu
Description
Specifies [Enable] or [Disable] for sadump function.
- Enable:Enable sadump
- Disable:Disable sadump
The default is [Disable].
Specifies format when sadump writes to dump
device.
-Uncompress:Data is not compressed
Specifies [Enable] or [Disable] for dump device
reuse. When [Enable] is specified, the oldest dump
is overwritten.
-Enable:Enable RECYCLE option
-Disable:Disable RECYCLE option
The default is [Enable].
Specifies behavior of sadump after dumping
-0:Halt
-1-3600:Reboots after specified time(second)
The default is [0].
Sets all items to default.
Saves the changes and exits this menu.
Cancels the changes and exits this menu.