Crankshaft Thrust Clearance - Suzuki Katana 1100 Service Manual

I
ENGINE 3-38
Bearing thickness specification
(Grooved bearing with oil hole ... For lower case)
Color (Part No.)
Specification
Green 1.486 - 1.490 mm
(12229-06BOO-OAO)
(0.0585 - 0.0587 in)
Black 1.490 - 1.494 mm
(12229-06BOO-OBO) (0.0587 - 0.0588 in)
Brown 1.494 - 1.498 mm
(12229-06BOO-OCO) (0.0588 - 0.0590 in)
Yellow 1.498 - 1.502 mm
( 12229-06BOO-ODO) (0.0590 - 0.0591 in)
NOTE:
*
Grooved bearings have the same specification as the
Grooved bearing with oil hole.
*
These parts numbers are shown as follows. 12229-06810­
xxx.
(Grooved bearing)
CRANKSHAFT THRUST CLEARANCE
• With the crankshaft, right-side thrust bearing and left-side
thrust bearing
thickness gaug
left-side.
inserted
e to mea
in
sure
the
the
upper
thrust clearance
crankcase, use
on the
a
NOTE:
Push the crankshaft to the starter clutch side, so that there is
no clearance on the right-side thrust bearing.
Thurst clearance
Standard:
0.04 - 0.08
mm
(0.002 - 0.003
in)
If the thrust clearance exceeds the standard range, adjust the
thrust clearance by the following procedures:
• Remove the right-side thrust bearing, and measure its
thickness with a micrometer. If the thickness of the right-side
thrust bearing is below standard, replace with a new bearing
and once again perform the thrust clearance measurement
listed above, checking to make sure it is within standard.
Right-side thrust bearing thickness
Standard:
2.44 - 2.46
mm
(0.096 - 0.097
in)
Upper
t
CD CD
CD CD
!
!
I
I
I I
CD
CD CD
CD
Lowe!
I I
Color code Color code
!
l
CD
Grooved bearing (For upper easel
~
I
CD
Grooved bearing with oil hole IFor 1 0 = : J
Upper case.,;,
¢=.
Push
7
Left bearing
Right bearing
II
',7
Front
I