Reassembly And Remounting - Suzuki Katana 1100 Service Manual

FUEl AND LUBRICATION SYSTEM 4-10
REASSEMBLY AND REMOUNTING
Reassemble and remount the carburetor assembly in the
reverse order of disassembly and removal.
Pay attention to the following points:
• Place the tongue
CD
of diaphragm to carburetor body
properly.
• When engaging two carburetors or two pairs of carburetors,
position the throttle valve control lever
®
correctly.
• Apply thread lock cement to the upper and lower plates'
screws.
99000-32040: Thread lock cement
• Align the starter shaft securing screw
CD
with dent mark
®
­
on the starter shaft and grease sliding portions.
-
•
• Set each throttle valve in such a way that its top end @ meets
the foremost by-pass @. This is accomplished by turning the
throttle stop screw and throttle valve balance screws.
• After all work is completed, mount the carburetors on the
engine and the following adjustments are necessary.
*
Engine idle r/min Page 2-9
*
Throttle cable play Page 2-9
*
Balancing carburetors Page 4-11