Suzuki Katana 1100 Service Manual page 83

3-53 ENGINE
• Install the primary driven gear assembly onto the counter ­
shaft, and apply engine oil to the needle bearing and spacer.
• Install the thrust washer
0
onto the countershaft.
• Install the clutch sleeve hub onto the countershaft.
• After tightening the clutch sleeve hub nut, be sure to lock
the nut by firmly bending the tongue of the washer. Tighten ­
ing torque for the nut is specified.
Tightening torque: 50 - 70 N·m
(5.0 - 7.0 kg-m. 36.0 - 50.5 Ib-ft)
09920-53722: Clutch sleeve hub holder
• Insert the clutch drive plate and driven plate one by one into
the sleeve hub in the prescribed order, drive plate first.
NOTE:
Two kinds of drive plate,
®
and @, are used, they resemble
each other in external appearance and configuration. But, drive
plates,
®
and @, can be distinguished by the painted (white).
• Install the clutch push rod
(1),
clutch push piece
0,
bearing
@
and thrust washer
(0
into the countershaft. Then, fit the
pressure plate onto the sleeve hub.
'A
2 pes 9 pes
• Tighten the clutch spring set bolts in the order as shown in
the Fig.
NOTE:
Tighten the clutch spring set bolts in the manner indicated,
tightening them by degrees until they attain a uniform
tightness.
Tightening torque: 11 - 13 N·m
(1.1 - 1.3 kg-m. 8.0 - 9.5 Ib-ft)