Suzuki Katana 1100 Service Manual page 43

3-13 ENGINE
• Remove the signal generator rotor by removing the bolt.
09914-25811: 6 mm
Hr'
type hexagon wrench
• Disconnect the oil pressure switch lead wire.
• Remove the signal generator stator by removing the three
screws.
• Remove the clutch cover by removing the bolts.
09911-73730: 5 mm
Hr'
type hexagon wrench
• By holding the conrod with a conrad stopper, remove the
clutch spring set bolts in a criss-cross manner.
"2
3
~*",
..... ' . . .
---------- "'!:lo. ...
.
'
09910-20116: Conrod stopper
~
1 - -
.
• After removal of pressure plate, remove the thrust washer
(1),
bearing
0
and clutch push piece
0,
and draw out the
.~
clutch push rods,
CD
and
@.
"'L(~
~
• Flatten the clutch sleeve hub nut lock washer by using chisel.
• Firmly secure clutch sleeve hub to remove mounting nut with
a clutch sleeve hub holder, and then remove the several
clutch drive and driven plates along with the clutch sleeve
hub.
09920-53722: Clutch sleeve hub holder