Suzuki Katana 1100 Service Manual page 93

3-63 ENGINE
NOTE:
Be sure to face the arrow mark on the cam chain idler to the
front.
• Tighten the four bolts to the specified torque.
Tightening torque: 9 - 11 N·m
(0.9 - 1.1 kg-m. 6.5 - 8.0 Ib-ft)
• Pour about 50 ml of engine oil in each oil pocket in the head.
• After removing the spring holder bolt
CD
and spring, unlock
the rachet mechanism
0
and push in the push rod
@
all the
2
way.
1
~
I
I
3
• Install a new gasket and the cam chain tensioner to the
cylinder block with two bolts and tighten them to the
specified torque.
Tightening torque: 6 - 8 N·m
(0.6 - 0.8 kg-m. 4.5 - 6.0 Ib-ft)
• Insert the spring into the cam chain tensioner and tighten
the spring holder bolt
CD
to the specified torque.
Tightening torque: 30 - 45 N·m
(3.0 - 4.5 kg-m. 21.5 - 32.5 Ib-ft)
CAUTION:
After installing the cam chain tensioner. check to be sure
that the tensioner work properly by checking the slack of
cam chain.
NOTE:
Turn the crankshaft and check that all the moving parts such
as cam follower, camshaft, work properly.
CAUTION:
Be sure to check and adjust the valve clearance. (Refer to
page 2-5.)