Suzuki Katana 1100 Service Manual page 86

ENGINE 3-56
• Install the starter idle gear and its shaft.
• Coat SUZUKI Bond No. 1207B lightly to the portion around
mating surface between upper and lower crankcases as
shown in the Fig.
99104-31140: SUZUKI Bond No. 1207B
• Install the dowel pin, a new gasket and starter clutch cover,
and tighten the cover bolts securely.
NOTE:
Fit up the gasket to the starter clutch cover bolt
®
correctly
as shown in the Fig.
CAUTION:
Use a new gasket to prevent oil leakage.
• Install the generator with three bolts.
Tightening torque: 21 - 29 N·m
.'
(2.1 - 2.9 kg-m, 15.0 - 21.0 Ib-ft)
NOTE:
Apply SUZUKI super grease "A" to the generator O-ring.
99000-25030: SUZUKI super grease "A"
• Install the starter motor with two bolts.
NOTE:
Apply SUZUKI super grease "A" to the starter motor O-ring.
Apply a small quantity of THREAD LOCK 1342" to the bolts.
U
99000-32050: Thread lock "1342"
• Install the piston rings in the order of oil ring, 2nd ring and
top ring.
• Top ring and 2nd ring differ in the shape of ring face.
~-----------------------
I (
.'OC