Starter Relay Inspection; Housing End (Gear-Side) - Suzuki Katana 1100 Service Manual

ElECTRICAL SYSTEM 6-14
HOUSING END (Gear-side)
• Apply grease to the lip of the oil seal.
99000-25030: SUZUKI super grease "Au
• Apply a small quantity of Thread Lock "1342" to the starter
motor housing screws and install both housing ends. (See
page 6-12.)
99000-32050: Thread lock "1342"
STARTER RELAY INSPECTION
• Remove the seat.
• Disconnect the lead wire of the starter motor at starter relay.
l
• Turn on the ignition switch, inspect the continuity between
the terminals, positive and negative, when squeezing the
clutch lever and pushing the starter button.
If the starter relay is in sound condition, continuity is found.
09900-25002: Pocket tester
I
_~
--l
----l I
~ ~ ~ - ~ - - - - - - - _ . - _ . _ - ~ - - -
• Disconnect the lead wires from the starter relay.
• Check the coil for "open", "ground" and ohmic resistance.
The coil is in good condition if the resistance is as follows.
o
09900-25002: Pocket tester
STD resistance: 3 - 5 D
I
l
~ ~
_