CHASSIS
7-46
!--_._--- --------
Inspect the swingarm pivot shaft runout with the dial gauge.
The swingarm pivot shaft must be replaced if the runout
r
exceeds the limit.
09900-20606: Dial gauge (1/100)
I
09900-20701: Magnetic stand (Not available in U.S.A.)
09900-21304: V-block (Not available in U.S.A.)
I
i
Service Limit: 0.3 mm (0.01 in)
,
I
1
Inspect the drive chain buffer for wear and damage.
REASSEMBLY AND REMOUNTING
Reassemble and remount the rear suspension in the reverse
order of disassembly and removal. Pay attention to the
following points:
CUSHION LEVER/ROD
• Apply grease to the bearings and dust seals.
99000-25030: SUZUKI super grease "A".
• Install the respective cushion lever and rod bearings with
proper socket wrench.
(Refer to page 7-47 for details.)
NOTE:
When installing the bearing, the stamped mark on the bearing
is positioned outside.
SWINGARM
• Apply grease to the bearings and dust seals.
99000-25030: SUZUKI super grease "A"
• Install the swingarm pivot bearings with proper socket
wrench.
NOTE:
When installing the bearing, the stamped mark on the bearing
is positioned outside.
I
'
I
-.-J
I