Suzuki Katana 1100 Service Manual page 89

3-59 ENGINE
• Place the six O-rings and two dowel pins on the cylinder.
CAUTION:
Replace the O-rings with new ones to prevent oil leakage.
• Be sure to replace the cylinder head gasket with new one
to prevent gas leakage.
NOTE:
Be sure to identify the top surface by "UP" mark
CD
on the
cylinder head gasket as shown in the Fig.
• Fit up the new O-rings onto the oil pipes and apply SUZUKI
--~------'·
.---- -_.. ... --. I
super grease "A"' to the O-rings.
~J--(1"
I
• Install the right and left oil pipes.
r
, I
99000-25030: SUZUKI super grease "AU
II
I
I
CAUTION:
Replace the O-rings (1) with new one to prevent oil leakage.
I
(t ­
!
L ,
---.J
• Place the cylinder head on the cylinder.
I----~A-' -f-~-------l
• Cylinder head nuts and washers must be fitted in the correct
,~{~
I
i
positions, as shown in the illustration.
®
Copper washer with cap nut (8 pes)
I
~~,:oo;
;
®
Copper washer with normal nut (4 pes)
i
I
I
@
I
' - ' ---.
I
\_~~~...-"
i
I
~.
- - - - - - - - - - - - - - - - - - - - - _ - - . 1
• Tighten the twelve 10-mm nuts to the specification with a
torque wrench sequentially in the ascending order of
numbers
Tightening torque:
35 - 40
N·m
(3.5 - 4.0
kg-m.
25.5 - 29.0
Ib-ft)
• After firmly tightening the twelve 10-mm nuts, install one
6-mm bolt
®
and tighten it to the specified torque.
Tightening torque: 7 -
11
N·m
(0.7 - 1.1
kg-m.
5.0 - 8.0
Ib-ft)