Suzuki Katana 1100 Service Manual page 88

ENGINE 3-58
• Be sure to install the pistons in the cylinder from which they
were taken out in disassembly, refer to the letter mark, "1"
through "4", scribed on the piston.
• Have each piston pin oiled lightly before installing it.
• Place a cloth beneath the piston, and install the circlips.
• Be sure to use new circlips.
• Before putting on the cylinder block, oil the big and small
ends of each conrod and also the sliding surface of each
piston.
• Place the dowel pins and new cylinder gasket on the
crankcase.
NOTE:
Be sure to identify the top surface by "UP" mark
CD
on the
cylinder gasket as shown in the Fig.
• Install piston ring holders in the indicated manner. Some
light resistance must be overcome to lower the cylinder
block.
• With No.2 and l\lo. 3 pistons in place, install NO.1 and No.
4 pistons, and insert them into the cylinder.
09916-74521: Holder body
09916-74540: Band
NOTE:
*
Do not overtighten the special tool bands or the cylinders
will resist to admit the pistons.
• Tighten the cylinder nut
®
to the specified torque.
Tightening torque: 7 - 11 N·m
(0.7 - 1.1 kg-m, 5.0 - 8.0 Ib-ft)