Wheel Bearing Reassembly And Remounting - Suzuki Katana 1100 Service Manual

---
CHASSIS 7-8
• Insert the adaptor into the wheel bearing.
• After inserting the wedge bar from the opposite side, lock
the wedge bar in the slit of the adaptor.
• Drive out the wheel bearing by knocking the wedge bar.
CAUTION:
The removed bearings should be replaced with new ones.
REASSEMBLY AND REMOUI\lTING
Reassemble and remount the front wheel in the reverse order
of removal and disassembly. Pay attention to the following
points:
WHEEL BEARING
• Apply grease to the bearings before installing.
99000-25030: SUZUKI super grease "A"
• Install the wheel bearings as follows by using the special
________-----.J
tool.
NOTE:
First install the left wheel bearing, then install the right wheel
bearing. The sealed cover on the bearing is positioned outside.
09924-84510: Bearing installer set
I
~--~
!
i
i
-~
-l
Front fork (L.H.)
Clearance
_
I,
L
I
I