3-15
ENGINE
• Remove the oil pump driven gear by removing the circlip.
09900-06107: Snap ring pliers
NOTE:
Do not lose the circlip, pin and washers.
• Remove the starter clutch cover by removing the bolts.
09911-73730: 5 mm "T" type hexagon wrench
• Remove the starter idle gear and its shaft.
• Loosen the starter clutch mounting bolt by using the special
tool.
09920-34810: Starter clutch holder
NOTE:
When removing the starter clutch assembly from the crank
shaft, do not remove the starter clutch mounting bolt after
loosening the bolt. The starter clutch mounting bolt is used in
conjunction with the special tool.
• Remove the starter clutch assembly from the crankshaft by
using the special tool.
09930-33720: Rotor remover